The HR300 unit incorporates 2 specially developed mixed flow fans for low noise and efficiency, with up
to 70% heat recovery. Effectively lowering internal relative humidity the HR300 unit controls
condensation and eliminates mould growth. Designed for through the wall mounting. Fresh, prewarmed
air from outside is continually provided to the room with simultaneous extraction of stale moist
air and smells. Heat is transferred via a unique plastic heat exchanger from outgoing air to the fresh air
supply with no cross contamination, maintaining internal temperatures and providing a fresh
environment. The unit is fully controllable for speed using a small dedicated speed controller.
n Automatic ON/OFF control or switching to boost is easily achieved using sensors/timers e.g.
humidistat. For summer operation the heatexchanger can be removed and replaced with a plastic
divider board to provide positive cooling to rooms.
n Available in three speeds: 75, 210 and 300m3/h. It is ideal for light commercial applications including
function rooms, offices and classrooms.
n Efficiency: The unit should retain up to 70% of the temperature differential of out going air.
n Heat exchanger: Should be of a multi plate cross-flow type constructed out of a polymeric plastic with
ultra sonic welded joints.
n Motor: Should be a 240V 50Hz AC with sleeve bearings and greased for life. It shall operate up to an
ambient temperature of 40oC and be fitted with a manual reset thermal overload protective device.
n Fan: The 2-¡° polymeric fan impellers should be of a mixed flow type, dynamically balanced mounted
on a fixed stator housing.
n Controls: The unit should be operated via a remote 3 Position switch, humidistat or a humidiswitch.
n Back Draught Shutter: The unit should have the option back draught shutter operated via a thermal
actuator set to close when unit is powered down.
n Filter: Should be a washable reticulated foam type coarse filter.
n Construction: The unit outer case should be a rigid ABS moulding.
n The internal/external grille should be a cream coloured ABS moulding.
n Complies to the following approvals/directives: LVD, EMC and CE.
E-mail:electrolux@t-home.mk
E-mail:natasa@electrolux.mk
Telephone-Bitola: +389 (0) 47 203 330
Telephone-Skopje: +389 02 3298 130
Telephone-Skopje: +389 02 3225 230
Fax:+389 (0) 47 203 900
Mobile Phone Number: +389 (0) 70 237 108